ANCEL PB100 Automotive Power Circuit Tester for ANCEL AD410 OBD II Code Reader

The ANCEL AD410 is a greatly enhanced upgrade from more basic car code readers. It has the capability to read and erase fault codes when the check engine light comes on, and it also shows real-time live data reported by the ECU, including engine temperature and O2 sensor readings, among other things. The device is easy to use, and no prior experience with diagnostic tools is required.

The PB100 automotive circuit tester probe is a must-have tool for both professional mechanics and home-use customers who are looking for a fast and accurate solution on 12V - 24V electrical power AVOmeter AC/DC voltage Diode Current Resistance diagnose. It helps you to activate components in the vehicle or W/Ground, read voltage displays red/green polarity LED, tracking, locate short circuits, and bad ground contacts.

With the PB100 circuit tester, you can check voltage and ground signals in a typical DC circuit, and you can also use it to send voltage and ground signals. It works like a test light that can power circuits or provide a good known ground, allowing you to effectively test components and circuits without having to break out the old alligator clips and jumper wires. You can power or ground a circuit directly through the top of the device.

The PB100 is a very handy tool for many functional circuit tests. You can use it to turn on a blower motor, run power window motors, windshield wipers, and even rear window defrosters. However, you should be careful when turning on anything with a motor, especially something with a motor-driven linkage.

The LED indicator on the front of the PB100 unit will show you the battery voltage when it is connected, which can be useful for determining a whole range of things, such as checking the alternator by plugging it in and starting the car. This is also helpful if you have a situation where a power supply has a large voltage drop, or if you notice low voltage on certain branches when checking fuses.

The PB100 has a built-in 8-amp circuit breaker to prevent circuit overload and overheating. Unlike a normal test lamp, this device can conduct direct battery current into the circuit you touch with it, so you need to know what you are doing when backfeeding a circuit. The breaker will protect the circuit, but 8 amps is still enough to do a lot of damage with the wrong wire.

The PB100 Circuit Tester features a long 20-foot cable that allows you to make the initial connection directly to the vehicle's battery, while providing easy access to connect the trailer harness at the rear of the vehicle. This is a recurring source of frustration for technicians across the country, especially those who service trailers exposed to road salt or salt water.

product information: